ArticleManagerSentimental time camera, when I opened my brother, I accidentally put the paint of others to a small piece. Because the old flower crown of 哥 is too long, the door is once opened, and there is no resistance. After this thing, the brother sherred the pain and decided to change it.
The normal door is open to a certain position, it is not opened, and it is necessary to push away, and the door is a significant resistance in the door. The reason why the brother’s door is not resistant, because the device is generated on the door, the limiter is broken, and the brother spent tens of oceans, bought a pair of limiters, because the front two doors are not It needs to be replaced.
The replacement limiter is actually relatively simple, and it will be opened. It is difficult to take the entire doorboard throughout the doorboard, and the door panels are basically used in plastic card. Only two screws, loosen the two screws, you can put all the door panels. Start the first step, the loose screw, nail the screw.
After the screw is taken, the door panel is started, and the door panel is basically caught by the plastic card, which can be dried slightly. It should be noted that the position of the electric control door has a joint, can’t pull, and pull it with force. After the clips and connections are loose, the whole doorboard will take it down. Then open a waterproof film, you can see the limiter. Take the limiter, you have to screw it slightly, you can take it out again.
As shown in the figure below, look at the old and new contrasts, everyone looks at the old limiter, directly with your hand, I know that there is no resistance. It is grinded because of the plastic sheets clamping it.喵 哥 看 这个 这个 没 没 没 死 死 死 死 死 死 死 死 死 死 死 死 死 死 死 死 死 死 死 死 死 死 死 死 死 死 死 死 死 料 料 料 料 料 料 料 料 料 料 料 料
Everyone looks back, as shown in the picture below, if you think it is, it is basically impossible, especially tight. Now, 喵 哥 will put the new limiter. And the steps taken are similar, first fix the position, and tighten the screws.
After replacing the restricted limiter, everyone will switch the door. Everyone will find the door switch, there will be a obvious damping, not like it, it is completely opened.
If after loading, the location of the limiter is too dry, or it can spray a little anti-rust lubricant, and the degree of lubrication will be better, and it is possible to prevent the limiter from rubbing the sound.
Before you go back, you can see the clip on the door panel, there is no damage to damage. There will be a card on the door of the brother, and like the brother is usually used, I have to put this kind of card, and put it back to the package.
It is okay to put the door plate. Before you go back, you can remember to post the waterproof film back. The glue above the waterproof film can be used multiple times, like this old flower, the waterproof film is more than ten years, still can be reused, but also sticky.
When everyone controls the line in the door panel, be sure to go to the place, otherwise the door panel will go back, and the glass can’t fall. Put the door board, you can place the casing hammer, and then go back on the two screws, the door limiter is replaced.
The limiter is still relatively simple. If you have a lot of lines on the door, you will worry about it. You can also buy your own accessories, find a car shop, you can get it.