It is not recommended to film for the aftermath glass of the car. In addition to the influence of the backwind glass defrosting the foggy function, in the later period, the film is replaced because the rear glass has resistance wires. It is easy to make the heating wire break and lose the window to remove the fog after losing the fog. Even if it is careful enough, it can be guaranteed to be able to tear off the entire membrane completely, which will easily cause damage to the resistance wire.
The “horizontal line” on the rear windshield is actually a resistance wire. When the rear windshield is fog and frost, the frost or water vapor on the rear windshield is dissolved and evaporated by the fever through the resistance wire. You need to press the inside of the car; allow the driver to have a clear rear sight to improve the driving safety factor. The vehicle with a rear windshield film cannot be turned on the heating function after half a year, otherwise the glass will continue to foam on the glass.
If the vehicle needs to pay attention to the car when using the resistance wire to work, it needs to be started in advance, because the heating resistance wire needs to consume a certain amount of electricity, avoiding that excessive discharge is not good for the battery; and it is necessary to keep it in time after the defrost is completed, otherwise it is easy to cause it to cause it easily to cause it. When the windshield is “dry and burned”, the glass will become abnormally fragile over time.