I have published a variety of hook -shirt tutorials, but today this sweater’s hook method will still make people shine. It is hooked from the cuffs, and this method is relatively special. I believe that through the study of today’s tutorial, you will appreciate the creativity and diversity of weaving. You will find that weaving sometimes does not need to follow the rules. On the contrary, you are courageous to innovate and shabby. Then this method can be retained. Well, not much to say, let’s take a look at the specific tutorial of this bat cooker hook shirt today. Demonstration line: Rainbow wool (dyeing line), 4.0mm hook needle.
Let’s first hook the sleeve, start with a needle from the side of the sleeve (need to be a strange needle), and demonstrate 31 stitches (you can try the size on the wrist). Line 1: Do not add or reduce hooks. One Chief needle; Line 2: 1 lock, turn over, start with the first needle, repeat (1 needle long needle, 1 needle internal hook long needle) cycle to hook, last 1 needle Long needle; Line 3: 1 lock, turn over, long needle hook long needle, hook long needle hook long needle, repeat the rules of line 2-3 to the length of the required sleeves (demonstration Hook is about 7 cm in length).
Then hook up the sleeve, line 1: Hook 2 stitches at the second needle at the head and tail, and other places do not reduce the hook long needle; starting the second line, we always repeat the rules of the first line, that is, the law of the first line, that is, Add the needle on the 2nd needle on the head and tail, and always hook the horizontal length of the sleeve film about 77 cm (at this time the total sleeve length is about 56 cm), and then we add a marker buckle at the center position (here is also the position of the shoulder start. To. Hook a slice of sleeves in the same way and add a mark buckle at the middle point.
Then we have to hook the front and rear pieces of clothes on the basis of the sleeve film. The center mark buckle of each sleeve is the place where the neckline starts. It is a chip hook, on the one side, the front film, and on the other side, the hook needle will be added to the required clothing length (the demonstration model is added with a 20 -pin needle, about 20 cm length). Let’s take a look at the specific operation: After adding the marking buckle at the center after the cuff is hooked, we re -access the line and hook out the 20 -needle lock needle; the first line: from the needle to add the hook lock needle to the marking buckle In front, turn back and forth without reducing the long needles to the required collar width (the demonstration model is about 20 cm width), and the other side is the same, and then the other sleeve is hooked in the same method according to the same method. Out of front and rear films.
Then we sew the clothes and sleeve slices separately. Finally, we came to pick the bottom of the hook: almost every row to pick 2 stitches and long needles (Note: When we pick the hook, put on the hook needle into the entity of the long needle to go. Pick up the hook and try not to pick the gap); in addition, how many needles are flexible, if you think you feel big, you can use it appropriately if you pick 2 stitches per line. The bottom edge of the long needle, 1 long needle), then the total number of needles requires even pins. If the bottom edge of the total needle is required if (2 stitches outside hook long needles, 2 stitches long needles), the total number of needles is 4, so as to This type. The bottom edge of the demonstration is the same as the sleeve side, and everyone hooks the length of the bottom edge they want. After the bottom edge is completed, this bat sleeve hook shirt is also completed ~!