Author: Brother John

Due to the large -scale snowfall in the country some time ago

I received a lot of fans’ private messages

Ask me how to choose the non -slip chain of the tire?

So I rejected a huge sum of money again

I bought 4 different materials and different characteristics of tire anti -slip chains

Hope to pass the following 4 evaluations

Help everyone choose the most suitable non -slip chain for your own car

“price comparison”

1. Manganese steel quenching chain -type non -slip chain (

Price: 195 yuan

雪地实测!几十块钱和几百块钱的防滑链,区别在哪里?

To.

It is mainly a n -type chain and a very thick steel cable composition. It is a very traditional non -slip chain. Nowadays, there are relatively few household cars because this chain has a little injury tire.

However, there are more vehicles or off -road vehicles. After all, this chain structure is still very strong.

雪地实测!几十块钱和几百块钱的防滑链,区别在哪里?

2. Steel wire roller -type non -slip chain (

Price: 188 yuan

雪地实测!几十块钱和几百块钱的防滑链,区别在哪里?

It is made of small drums that are covered on the steel cable. It looks simple and light, and it is relatively convenient to carry.

3. Rubber steel nail -type non -slip chain (

Price: 297 yuan

It is the most expensive product in this test. The main non -slip part is a mesh structure made of sulfurized rubber, then made of steel nails, and then connected with a whole steel cable.

But it is a bit bulky and it is not convenient to carry. The volume of the two non -slip chains is almost catching up with a 20 -inch suitcase.

雪地实测!几十块钱和几百块钱的防滑链,区别在哪里?

4. Simple anti -slip chain (

Price: 20 roots/21.6 yuan

It is actually a large plastic tie. To be honest, I am not optimistic about it, because it has broken one on the way to transport … so I feel that it is only theoretically non -slip.

“Drinking difficulty test”

Installation time: 2 minutes and 38 seconds, disassembly time: 1 minute and 20 seconds

Its installation method is very simple. First, the steel cable is wrapped behind the tire, and then connected to the buckle on the upper end of the steel cable, and then the chain can be surrounded by the whole side of the tire.

Then hook the buckle of the outer chain of the tire, finally tighten the fixed chain, bypass a buckle, and then hook it on the chain above to form a triangle OK.

雪地实测!几十块钱和几百块钱的防滑链,区别在哪里?

I installed a wheel and took about 2 minutes and 38 seconds. I won’t go into details when the disassembly process is removed. The installation process is in turn. I use it for about 1 minute and 20 seconds.

Here I suggest that you can use the jack on the top of the jack to let the tires hang out to install the anti -slip chain, which will be more convenient.

And I strongly do not recommend opening the tire to the anti -sliding chain and then installation, which can easily cause the installation to not be in place.

And in fact, for our ordinary car owners, the installation of the jack will be faster. The correct way to use the jack can look back at Episode 197 of “Master of the Car” in the previous program (

At the critical moment, the skill of saving money and life -saving, but many car owners make mistakes? Hurry up to make up the class

), I will definitely help you.

Installation time: 2 minutes, disassembly time: 1 minute

The installation of rolling beads is very simple. You only need to buckle the steel cable buckle on both sides of the inside and outside of the tire. Of course, you must ensure that the steel cable is tight. The steel ropes are fine.

I installed a total of about 2 minutes, and it took about 1 minute to remove it.

And I still recommend that you use the tire to install it with a jack, so that you can install it more well, not easy to loosen.

Installation time: 7 minutes and 50 seconds, disassembly time: 1 minute and 20 seconds

First, the anti -slip chain is fully expanded, then the non -slip chain is stuffed from the tire to the back of the tire, and then the hand is extended into the rear side of the tire. The steel cable inside is buckled first.

Then hook the metal hook at the non -slip chain connection, and then pull the anti -sliding chain to pull evenly on the tire. This step is to use a little.

雪地实测!几十块钱和几百块钱的防滑链,区别在哪里?

Finally, use a dedicated latter to hook 2 to 3 rubber tendons to hook the hook of the exterior anti -slip chain of the entire tire and install it. This is to ensure that the anti -slip chain will not fall off.

I installed about 7 minutes and 50 seconds, and the anti -slip chain was also very strenuous. I took it for 1 minute and 33 seconds to remove it.

At present, I personally think that the most laborious anti -slip chain is installed, and the two sleeves of my clothes are soiled when I install it …

Installation time: 4 minutes and 28 seconds, disassembly time: disassemble 1 3 seconds

This is really simple. Just pull the tie through the wheels, and then pull the non -slip and raised side to pull tightly.

For example, the wheels of my car have a total of ten disks, which can be equipped with nine tie -shaped anti -slip chains. Because the tie anti -sliding chain may move left and right in the disk, the spokes with a valve can not be installed.

Another thing to note is that you should also avoid the brake oil pipe during installation. Do not tie the brake oil pipe and wheels together. If the car moves, the oil pipe will be broken.

Although the tie -type non -slip chain is simple to install, it is time to install nine roots. I spent 4 minutes and 28 seconds in a wheel. It is easy to remove it. It can be completed, so the disassembly time can be ignored.

雪地实测!几十块钱和几百块钱的防滑链,区别在哪里?

Fortunately, installing this non -slip tie no need to use the jack, so it is simple to get started, but the disadvantage of this play is one -time, how much is a bit wasteful …

(Note! All the time in this test includes the time to use the pound to push up the car, because I use the horizontal jack, which will be relatively faster. About 2 minutes.)

雪地实测!几十块钱和几百块钱的防滑链,区别在哪里?

in conclusion:

The hardest to install is the rubber steel nail -type non -slip chain, which can be said to be time -consuming and laborious.

Secondly, the steel wire roller -shaped non -slip chain. Although it is not very time -consuming, it needs to be miracle during installation. It is not friendly for the owner of the small strength.

Relatively easier is manganese steel quenching chain -type non -slip chains. Men and women owners of normal physique have the strength to install it.

The simplest is the simple and simple anti -slip chain, and children can easily get it.

“Anti -slip effect test”

In the morning in a heavy snowy day, I took a heavy snow to find a test with a length of 30 meters and about 15 degrees. Ice cement pavement.

For the fairness of the anti -slip chain test effect, I use Land Rover’s ATPC mode every time I go uphill.

In this mode, I will set the speed to a fixed value. The driving computer will dynamically adjust the output torque of each wheel according to the slide of each wheel to ensure that the car advances at the set speed.

And I do n’t step on the accelerator throughout the process, so the smaller the theoretical tire slippery, the faster the uphill speed.

Because it is a four -wheel drive uphill test, I will install it on the two rear wheels in each set of anti -slip chains.

Uphill time: 42 seconds

When the car is uphill, it can be seen that it pauses very much. This is because the driving computer detects that the wheels are sliding and start to adjust the torque output of each wheel.

雪地实测!几十块钱和几百块钱的防滑链,区别在哪里?

So after a brief pause, the car climbed up the slippery snowy long slope for 42 seconds.

Uphill time: 48 seconds

It also appeared obviously after uphill, and then I started climbing. What I need to explain here is that every time I climb the hill, I will avoid the folding formed on the snow. Smoothing the anti -slip chain, more accurate anti -slip effect.

After 48 seconds, the car also successfully climbed up to the long slope.

Uphill time: 46 seconds

To be honest, I originally thought that its non -slip effect was the worst, but the car climbed up the sliding big slope in 46 seconds, which made me a little surprise.

Uphill time: No grades

The most embarrassing is the simple and simple anti -slip chain. After installing it, the road to the long slope is broken. After opening it for ten meters, the tie -tie anti -slip chain on one side is broken. The next four … The last side was opened on one side, only two left …

雪地实测!几十块钱和几百块钱的防滑链,区别在哪里?

Then I really didn’t dare to open it. I was afraid that the brake oil pipes that would be pulled to the rear wheels after the non -slip chain was broken, and it would be worth it.

The best non -slip effect is the non -slip chain of manganese steel quenching chain, followed by rubber steel nail -type non -slip chains. Finally, the steel wire roller -type anti -slip chain, while the simple non -slip chain is not passed by this test.

“Matching models”

(This is my personal subjective conclusion, for your reference only)

雪地实测!几十块钱和几百块钱的防滑链,区别在哪里?

Suitable for off -road vehicles, loading cars

If your car is an off -road vehicle or a tool car, which is usually a car to make money, then it is suitable for the use of manganese steel quenching chain -type non -slip chains.

Because its non -slip effect is the best, and it is sturdy and durable. The installation is simple and cost -effective.

The disadvantage is that it has a large work noise and has a great damage to the tires and wheels, especially it is very harmful to the tire, so it is recommended to use AT tires.

Suitable for long -distance station wagon

雪地实测!几十块钱和几百块钱的防滑链,区别在哪里?

This non -slip chain is moderate and noisy, and the anti -slip effect is also said. The biggest feature is that it is lightweight, lighter than rubber steel nail -type anti -slip chains.

Therefore, it is more suitable for models that are not enough for luggage space on the car when going out to play.

Suitable for home vehicles

Although it is the most expensive and time -consuming is time -consuming, it is minimal to the tires and wheels, and it can almost ignore it.

雪地实测!几十块钱和几百块钱的防滑链,区别在哪里?

And it has the largest fit area with the tire, and it should also be the least easy to fall off, so it is safer, and the noise and vibration it produces are also the smallest, so it is very suitable for household cars.

雪地实测!几十块钱和几百块钱的防滑链,区别在哪里?

Not recommended

I feel that it can only be used on the road with a certain snow thickness. It cannot be used on the uneven road, because the plastic itself is crispy in winter, and the ground is uneven, it is easy to break.

Therefore, it can only be used as an emergency anti -skid tool. Although there is a bit of non -slip effect, I still don’t recommend everyone to use it.

Of course, in the end, it is important to explain that after installation of any anti -slip chain, the speed should not exceed 40 kilometers per hour. After all, safety is first ~

The above is my evaluation of these 4 tires’ anti -slip chains. I hope to help everyone ~

If this article is helpful for you to buy the anti -slip chain, then please forward it and share it with your friends, and help me like it. If you want to get more hands -on -minded cars, or see me for more auto supplies testing videos, then please pay attention to the update of Brother Che every Wednesday and Friday.

1. Manganese steel quenching chain -type non -slip chain (

1. Manganese steel quenching chain -type non -slip chain (

1. Manganese steel quenching chain -type non -slip chain (

雪地实测!几十块钱和几百块钱的防滑链,区别在哪里?

To.

To.

雪地实测!几十块钱和几百块钱的防滑链,区别在哪里?

To.

雪地实测!几十块钱和几百块钱的防滑链,区别在哪里?

To.

To.

To.

To.

雪地实测!几十块钱和几百块钱的防滑链,区别在哪里?

To.

To.

雪地实测!几十块钱和几百块钱的防滑链,区别在哪里?

To.

To.

To.

To.

To.

To.

2. Steel wire roller -type non -slip chain (

2. Steel wire roller -type non -slip chain (

2. Steel wire roller -type non -slip chain (

3. Rubber steel nail -type non -slip chain (

雪地实测!几十块钱和几百块钱的防滑链,区别在哪里?

3. Rubber steel nail -type non -slip chain (

3. Rubber steel nail -type non -slip chain (

4. Simple anti -slip chain (

4. Simple anti -slip chain (

4. Simple anti -slip chain (

in conclusion:

You might also enjoy: